THOMSON SpeedTouch 516 Setup And User Manual page 17

Installing the
SpeedTouch™ USB
connection
E-DOC-CTC-20040907-0001 v1.0
The installation is plug and play, meaning that installation will require almost no
effort.
Proceed as follows:
1
Insert the blue USB cable provided into the SpeedTouch™ USB port marked
with the USB logo:
2
The other end of the USB cable fits in (one of) the USB port(s) of your PC. In
most cases your PC's USB port is marked with the same USB symbol.
You can also connect your PC to the SpeedTouch™ via a USB hub.
3
Windows will automatically recognize the Thomson USB Remote NDIS device:
4
The Windows Found New Hardware Wizard appears:
This wizard will guide you through the installation procedure of the USB
drivers.
Click Next to continue.
The Windows Found New Hardware Wizard may ask your
authorisation to connect to Window Update to search for software. If
this is the case, select No, not this time and click Next.
5
The following window allows you to select locations where it should search
for drivers:
Insert the SpeedTouch™ Setup CD-ROM, make sure that the wizard looks for
the drivers on the CD-ROM drive and click Next to continue.
6
The wizard will notify that it found drivers for the device on the CD-ROM.
Click Next to continue.
7
The installation procedure continues with the installation of the USB drivers.
8
In the following windows you can follow the installation procedure. Click Next
whenever requested to continue the installation.
.
Chapter 1
SpeedTouch™ Installation
15