THOMSON SPEEDTOUCH 516 User Manual page 114

Chapter 6
Troubleshooting
Resetting your
SpeedTouch™
Hardware reset
Software reset
112
6.3 Reset to Factory Defaults
You might consider a reset to factory defaults as described below.
Be aware that a reset to factory defaults will revoke all configurational
!
changes you made to the SpeedTouch™.
You can choose between:
Hardware reset
Software reset
A reset to factory default settings deletes the configuration profile settings.
Therefore, after the reset, a reconfiguration of your SpeedTouch™ will be needed.
Also your WLAN clients will have to be re-associated, as described in
"2.3.2 Connecting First-time Wireless Clients" on page
Proceed as follows:
Make sure the SpeedTouch™ is powered on.
1
Use a pen or an unfolded paperclip to push the recessed reset button on the
2
back panel. The reset button is marked with a red circle. Keep it pushed until
the power LED lights red - this will take about 7 seconds.
Release the reset button.
3
The SpeedTouch™ restarts.
4
Proceed as follows:
Go to the SpeedTouch™ web pages.
1
In the menu select SpeedTouch > Configuration.
2
In the Pick a task... list, click Reset my SpeedTouch to default settings.
3
The SpeedTouch™ restarts.
4
The SpeedTouch™ returns to the SpeedTouch™ Home page (unless the IP
5
address of your computer is not in the same subnet as the default IP address of
the SpeedTouch™, being 192.168.1.254).
15VAC ON/OFF
1
30.
2 3 4
E-DOC-CTC-20050120-0003 v1.0