Clutch Housing; Engine - Graco 3400 Repair Manual

Removal
1. Remove clamp. Do Clamp Removal, page 10.
2. F . 10. Remove four screws (60) and lock washers (59)
IG
which hold clutch housing (51) to engine.
3. Remove screw (64) from under mounting plate (D).
4. Pull off clutch housing (51).
Installation
1. F . 10. Push on clutch housing (51).
IG
2. Install four capscrews (60) and lock washers (59) and
secure clutch housing (51) to engine. Torque to 200 in-lb
(22.6 N·m).
3. Install screw (64) from beneath mounting plate (D).
Torque to 26 ft-lb (35.2 N·m).
Removal
NOTE: All service to the engine must be performed by
an authorized HONDA dealer.
1. Remove Pinion Assembly/Clutch Armature/Clamp and
Clutch Housing, as instructed on pages 9, 10 and 11.
2. F . 11. Disconnect all necessary wiring.
IG
3. F . 12. Remove two locknuts (3) and screws (2) from
IG
base of engine.
4. Lift engine carefully and place on work bench.
F . 11
IG
310813 Rev C

Clutch Housing

F . 10
IG

Engine

F . 12
IG
Installation
1. Lift engine carefully and place on cart.
2. F
IG
secure with locknuts (3). Torque to 20 ft-lb (27.12 N·m).
3. F
IG
4. Install Pinion Assembly/Clutch Armature/Clamp and
Clutch Housing, as instructed on pages 9 and 10 and 11.
5. Set engine to 3300 rpm.
. 12. Install two screws (2) in base of engine and
. 11. Connect all necessary wiring.
Clutch Housing
11