Remote Operation - Dimplex DF203A Owner's Manual

Operation
automatic cut out will turn the
heater off and it will not come
back on without being reset. It
can be reset by switching the
3-Position Switch to OFF and
waiting 5 minutes before switch-
ing the unit back on.
CAUTION: If you need to con-
tinuously reset the heater, unplug
the unit and call technical support
at 1-888-346-7539.

Remote Operation

The fireplace is supplied with an
integrated On/Off
!
NOTE: Ensure that the fire-
place 3 position switch is set to
the remote control setting. To
operate, push the ON button to
turn fireplace on, push the OFF
button to turn the fireplace
!
NOTE: Before attempting any
operation with the remote control,
pull the plastic insulator strip out
from between the remote casing
and battery cover.
Remote Control Initialization/
Reprogram
In the event that your remote
control ceases to operate your
fireplace, follow these steps to
reinitialize the remote control and
the remote control receiver in the
12
remote control.
off.
fireplace:
1. Place the 3-Position Switch
(Figure 9A) in the OFF ("O")
position.
2. Wait a minimum of 5 seconds
and then place the 3-Position
Switch in the Remote Control
position.
3. Within 10 seconds of chang-
ing the switch position, press
the ON button located on the
remote control (Figure 10).
This will synchronize the re-
mote control and the fireplace
receiver.
! NOTE: You will have only 10
seconds to perform this last step.
Failure to do so will result in these
steps needing to be followed
again.
Figure 10
On
Button
Off
Button
Plastic
strip
Battery
cover
www.dimplex.com