Setup For Netware; Netware Using Ndps Over Ip - Axis 5400 User Manual

Axis print servers high performance multi-protocol print servers for virtually all networks

Hide thumbs Also See for 5400:

Table of Contents

Setup for NetWare

Important:

If you want to print in NDPS, make sure that you have NDPS software installed on your NetWare

file server.

Note:

You can select to install the connected printers as Public or Controlled Access printers.

Having assigned an IP address to the AXIS 5400/AXIS 5600 as described in Assigning

an IP Address, on page 8, you are now ready to install the AXIS 5400/AXIS 5600 for

NDPS printing over IP. Follow the instructions below:

1. Connect the AXIS 5400/AXIS 5600 to the NetWare network, if it is not already

connected. Refer to Connecting the printer to the Ethernet Network, on page 7 for

more information.

2. Start the NetWare Administrator. Create an NDPS Manager object, if you do not

have one available.

3. Proceed to create the printer object as a public or controlled access printer.

Please refer to the appropriate Novell documentation for instructions on creating

NDPS Manager objects and the NDPS printers.

Notes:

The HP-JETADMIN parameter of the AXIS 5400/AXIS 5600 must be set to YES in order for the

communication between the AXIS 5400/AXIS 5600 and the NDPS gateway to be enabled.

NDPS requires NetWare 4.11, or higher.

During the creation of the printer object, you must choose the IP address of the AXIS 5400/AXIS

5600.

To print using TCP/IP, Axis print server firmware 6.1 or later is required. In order to print using

IPX/SPX, Axis print server firmware 5.51 or later is needed.

AXIS 5400/AXIS 5600 User's Guide

Table of Contents

5600