Acquiring Satellite Signals; Optional Ant+ Sensors - Garmin EDGE 500 Owner's Manual

Getting Started
Acquiring Satellite
Signals
It may take 30 to 60 seconds to acquire
signals.
1. Go outdoors to an open area.
2. Make sure that the front of the Edge
is oriented toward the sky.
3. Wait while the Edge searches for
satellites.
Do not begin moving until the
locating satellite page disappears.
NOTE: To turn off the GPS receiver
and use the Edge indoors, see
page 45.


Optional ANT+ Sensors

NOTE: If you do not need to set up
ANT+ sensors, you can skip this step.
To use an ANT+ sensor during your
ride, you must install it and pair it with
the Edge.
• For heart rate monitor instructions,
see page 21.
• For GSC 10 speed and cadence
™
sensor instructions, see
• For third-party ANT+ sensors, see
page 30, refer to the manufacturer's
instructions, and go to
www.garmin.com/intosports.
Edge 500 Owner's Manual
page 25.