Wiring The Power Input - Planet MGSW-24160F User Manual

2.2.4 Wiring the Power Input

The 6-contact terminal block connector on the rear panel of MGSW-24160F is used for two DC redundant powers input. Please
follow the steps below to insert the power wire.
1. Insert positive / negative DC power wires into the contacts 1 and 2 for DC POWER 1, or 5 and 6 for DC POWER 2.
2. Tighten the wire-clamp screws for preventing the wires from loosing.
The wire gauge for the terminal block should be in the range between 12 ~ 24 AWG.
Figure 2-9 Wiring the Redundant Power Inputs
1 2 3
DC 1
+ -
Figure 2-10 6-Pin Terminal Block Power Wiring Input
36
User's Manual of MGSW-24160F
4 5 6
DC 2
+ -