Axis 5800 User Manual page 145

AXIS 5800+ Mobile User's Manual
Factory Default
Settings
Note:
Follow the instructions below to reset the AXIS 5800+ Mobile to the
factory default settings:
1. Remove the external power supply to switch off the AXIS 5800+
Mobile.
2. Press and hold down the test button, while you plug the external
power supply back in. Continue to hold down the test button,
until the network indicator begins to flash at one second
intervals. This should take at least 5 seconds.
3. Release the test button and wait until the network indicator
flashes at least five times.
4. Press and hold the test button again until the network indicator
remains constantly lit.
5. Restart the AXIS 5800+ Mobile by disconnecting and
reconnecting the external power supply.
The AXIS 5800+ Mobile is now reset to factory default settings.
• All parameters except Node Address (NODE_ADDR), Internet
Address (IP_ADDR) and DHCP enabled or disabled
(DHCP_ENABLE.) are reset. If you want to change the these
parameters, use any standard Web browser. Please refer to
Section 11 Management and Configuration, on page 102.
Section 13 Test Button
145