Rinnai Continuous Flow Water Heaters Operation Manual page 17

Bathroom Deluxe Controller
Setting the The clock is a 12 hour AM/PM display. To set the time press the 'Clock'
clock button once. In the digital monitor the clock digits will flash, if this is the
first time the clock has been set the starting time will be AM 12:00.
Use the up and down buttons to select the desired time. Holding these
buttons down continuously cycles the digits. When you get close to the time
you wish to set, press the button intermittently to avoid going further than
the desired time.
To return to normal mode, press the 'Clock' button once. If no buttons are
pressed for approximately 60 seconds the controller will return to normal
mode.
The time is always displayed regardless of whether the controller is turned
On or Off. The clock may need resetting if power to the water heater is
disrupted due to a power failure or if the power is switched off over a
prolonged period.
Setting the To set the sound options press the 'Sound Volume' button and select the
sound options desired audible setting as follows:
•
•
Press the up and down buttons to return to normal mode. If no buttons are
pressed for approximately 10 seconds the controller will return to normal
mode.
Adjusting Press the 'Temperature' up and down buttons until the required temperature
temperature is displayed.
Once the hot water is running, if the set temperature is either too hot
or cold, press the 'Temperature' up and down buttons until the desired
temperature is reached.
Rinnai New Zealand
Voice High, Med, Low or off, sets the voice prompt volume but does not
affect the 'beep' sound when pressing the buttons
Sound Off, mutes all voice prompts and audible tones.
Continuous Flow Water Heater Operation Manual
17
01-09