Electrolux EWN 14991 K User Manual page 18

electrolux use
18
Press the button
programme
To start the selected programme, press
7
the button ; the green pilot light stops
blinking.
On the display will appear the icon, and
alternatively the name and the running
phase of the selected programme to
indicate that the appliance starts
operating and the door is locked.
To interrupt a programme which is
running, press the button
pilot light starts blinking and the icon of
the selected programme appears on the
display, the message «Press
continue» appears for some seconds
and then the message «Paused» to
indicate that the appliance is paused.
To restart the programme from the point
at which it was interrupted, press the
7
button again.
If you have chosen a delayed start, the
machine will begin the countdown.
Altering an option or a running
programme
It is possible to change only the options
vizualised on the display by pressing the
5
buttons (Up or Down) before the
programme carries them out. Before you
make any change, you must pause the
washing machine by pressing the button
7
.
Changing a running programme is
possible only by resetting it. Turn the
programme selector dial to «O» and then
to the new programme position, press
6
the button to cancel the previous
washing programme. Start the new
programme by pressing the button
again. The washing water in the tub will
not emptied out.
7
to start the
7
: the green
to
7
Interrupting a programme
Press the button
programme which is running, the
corresponding light starts blinking. Press
the button again to restart the
programme.
Cancelling a programme
Turn the selector dial to «O» and then
in the new selected programme.
Press the button
programme which is running.
Now press the button
new programme.
Opening the door after the
programme has started
7
Press the button
pause. The corresponding message will
appear on the display.
If the door cannot be opened, this means
that the machine is already heating, that
the water level is above the bottom edge
of the door.
In this case the door can not be opened.
If you cannot open the door but you need
to open it you have to switch the machine
off by turning the selector dial to «O». After
some minutes the door can be opened
(pay attention to the water level
and temperature!).
At the end of the programme
The machine stops automatically.
If the Rinse Hold or Night Cycle
options have been selected, the pilot
7
light of button
the selected programme and the
message «Finished» appears on the
display and the door remains locked to
indicate that the water must be
emptied out before opening the door.
7
to interrupt a
6
to cancel the
7
to start the
to set the machine to
goes off, the icon of