Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Electrolux EWN 1030
Summary of Contents for Electrolux EWN 1030
- Page 1 W A S H I N G M A C H I N E T V Ä T T M A S K I N P Y Y K I N P E S U K O N E S T I R A L W N A Å M A fi I N A INSTRUCTION BOOKLET BRUKSANVISNING KÄYTTÖOHJE...
-
Page 2: Table Of Contents
Dear customer, Transport damages Please read these operating instructions carefully When unpacking the appliance, check that it is not and pay particular attention to the safety notes damaged. If in doubt, do not use it and contact the indicated in the first pages. We recommend that you Service Centre. -
Page 3: Warnings
Warnings The following warnings are provided in the interests of overall safety. You must read them carefully before installing or using the appliance. Installation General safety • All internal packing must be removed before using • Repairs to the machine must be carried out only by the appliance. -
Page 4: Disposal
(the environment is protected too!). laundry being washed. • The machine works more economically if it is fully loaded. Technical specifications EWN 1030 EWN 1220 EWN 1220 A DIMENSIONS Height 85 cm... -
Page 5: Installation
Installation Unpacking Remove the polystyrene base. Set the machine upright and unscrew the remaining rear screw. Slide out the relevant pin. All transit bolts and packing must be removed Fill all the holes with the plastic plugs supplied with before using the appliance. the instruction booklet. -
Page 6: Water Drainage
The inlet hose must not be lengthened. If it is too Electrical connection short and you do not wish to move the tap, you will This machine is designed to operate on a 220-230 V, have to purchase a new, longer hose specially single-phase, 50 Hz supply. -
Page 7: Your New Washing Machine
Your new washing machine This new washing machine, which is fitted with the Jet system, patented Electrolux, meets all modern needs for effective treatment of laundry with low water, energy and detergent consumption. Further savings are achieved by washing small loads of laundry, since water and electricity consumption is proportional to the quantity and type of laundry being washed. -
Page 8: Use
The relevant light will light up. operating buttons 4 and 5. Maximum speeds are: • for cotton: 1000 rpm for model EWN 1030; Hand wash 1200 rpm for model EWN 1220; When you select this programme, you obtain a 1200 rpm for model EWN 1220 A;... -
Page 9: Options Button
options: 8 Display • Draining and spin The following pieces of information are shown on the - Press the START/PAUSE button. The machine will display: drain the water, then spin the laundry at the maximum • Three blinking dashes, when a programme is speed provided for the selected programme. -
Page 10: Skip/Reset Button
Important! 9 START/PAUSE button The first time you use the washing machine, This button has three functions: when you switch it on, it may display a blinking zero and give an audible warning signal. This is due to the fact •... - Page 11 This button allows you also to select special If you have already pressed the START/PAUSE programmes, such as RINSES, SPIN and DRAIN. button, and you wish to change or cancel the delay time, proceed as follows: • If the machine is already switched on because it has just performed a washing programme, proceed •...
-
Page 12: Washing Hints
Laundry weights Washing hints The following weights are indicative: bathrobe 1200 g Sorting the laundry napkin 100 g Follow the wash code symbols on each garment quilt cover 700 g label and the manufacturer’s washing instructions. sheet 500 g Sort the laundry as follows: whites, coloureds, synthetics, delicates, woollens. -
Page 13: Detergents And Additives
Ink: depending on the type of ink, moisten the fabric Quantity of detergent to be used first with acetone (*), then with acetic acid; treat any The type and quantity of detergent will depend on residual marks on white fabrics with bleach and then the type of fabric, load size, degree of soiling and rinse thoroughly. -
Page 14: International Wash Code Symbols
International wash code symbols These symbols appear on fabric labels, in order to help you choose the best way to treat your laundry. Energetic wash Max. wash Max. wash Max. wash Max. wash temperature temperature temperature temperature 95°C 60°C 40°C 30°C Hand wash Do not... -
Page 15: Operating Sequence
4. Switch the machine on Operating sequence Press the ON/OFF button to switch the machine on. The display will show three blinking dashes or a Before washing your first load of laundry, we blinking zero. The light above the button will light up. recommend that you run a cotton cycle at 60°C, with the machine empty, in order to remove any manufacturing residue from the drum and tub. - Page 16 6. Select the temperature 9. Select the DELAY TIME Press the TEMPERATURE button if you wish to Before you start the programme, if you wish the select a temperature value different from the one starting to be delayed, press the DELAY button (11) proposed by the washing machine.
- Page 17 11. How to change a programme during Pay attention to the level and temperature of the water in the washing machine! its cycle When you close the door and press the ON/OFF Before you make any change, you must pause the button again, the washing machine will resume the washing machine by pressing the START/PAUSE programme from the point where it had been...
-
Page 18: Washing Programmes
Washing programmes Type of Consumption* laundry and Programme/ Description of Available options symbols on load temperature programme Energy Water Time labels litres h/min. Main wash at 2.29 Cottons 5 kg White cotton: 60°-95°C 60°-95°C e.g. sheets, 3 rinses tablecloths, Long spin household linen Main wash at... -
Page 19: Maintenance
Maintenance Door seal Detergent can also accumulate inside the drawer recess: clean it with an old toothbrush. Refit the Check from time to time the door seal and eliminate drawer after cleaning. eventual possible objects that could be trapped in the fold. -
Page 20: Water Inlet Filter
• Remove any objects from the pump impeller by Emergency emptying out rotating it. If the water is not discharged, proceed as follows to empty out the machine: • pull out the plug from the power socket; • close the water tap; •... -
Page 21: Something Not Working
Something not working? Problems which you can resolve yourself. During machine operation it is possible that one of the following alarm codes appears on the display: - E10: problem with the water supply - E20: problem with water draining - E40: door open At the same time the buzzer sounds. -
Page 22: The Door Will Not Open
Problem Possible cause • The door will not open: • The water level is above the bottom edge of the door. • The machine is heating the water. • The drum is turning. The door can only be opened when the relevant light has gone out.