Electrical Connection - Electrolux ESI 6220 User Instructions

Electrical Connection

Any electrical work required to install this
appliance should be carried out by a qualified
electrician or competent person.
WARNING - This appliance must be
1
earthed.
The manufacturer declines any responsi-
bility should these safety measures not
be observed.
Before switching on make sure the electricity supply
voltage is the same as that indicated on the appliance
rating plate.
To isolate the dishwasher from the mains, remove the
mains plug.
Important: The plug must still be accessible after the
appliance has been installed.
Changing a fuse
The appliance is supplied with a 13amp plug fitted. In
the event of having to change the fuse in the plug
supplied, a 13amp ASTA approved (BS 1363A) fuse
must be used.
Should the plug need to be replaced for any reason,
proceed as described below.
The wires on the mains lead are coloured in accord-
ance with the following code.
Green and Yellow : Earth
Blue : Neutral
Brown : Live
• The wire coloured green and yellow must be con-
nected to the terminal marked with the letter "E" or
by the earth symbol
low.
• The wire coloured blue must be connected to the
terminal "N" or coloured black.
• The wire coloured brown must be connected to
the terminal marked "L" or coloured red.
• Upon completion there must be no cut, or stray
strands of wire present and the cord clamp must
be secure over the outer sheath.
WARNING! A cut off plug inserted into a
1
13 amp socket is a serious safety (shock)
hazard. Ensure that, if it is necessary to
cut off the plug, it is disposed of safely
and not retained.
36
or coloured green and yel-
Green
& Yellow
Blue
Cord Clamp
Brown