What To Do If; Error Messages Are Displayed - Electrolux ESI 6220 User Instructions

What to do if ...

Try to rectify minor faults on the dishwasher with the
aid of the instructions given here. If you call in cus-
tomer service to resolve one of the malfunctions
listed here, or rectify an error made in the operation
of the appliance, the customer service engineer's visit
is not free of charge, even during the period of guar-
antee.

...Error messages are displayed.

If any of the indicators in the control panel, as listed in
the table below, are flashing or are illuminated, you
can probably rectify the fault yourself.
Malfunction
The programme indicator for the
selected wash programme is flashing;
the end wash programme indicator is
flashing in the following
sequence: 1 short flash with approx.
3 seconds pause in between:
There is no water entering the dish-
washer.
The programme indicator for the
selected wash programme is flashing,
the end wash programme indicator is
flashing in the following sequence: 2
short flashes one after the other.
The end wash programme indicator is
flashing in the following sequence: 3
short flashes, one after the other.
After remedying the error that is flashing in the first
or second sequence in the programme progress
display, press the button for the wash programme that
had already started. The wash programme will con-
tinue.
If the fault is displayed again, please contact your
local Service Force Centre.
For all other errors displayed, please contact
3
Service Force, stating the error code. (See
chapter "Customer Service").
26
Possible cause
The tap is blocked or furred with
lime-scale
The tap is turned off.
The filter (where present) in the
threaded hose fitting on the tap is
blocked.
Filters in the base of the washing
compartment are blocked.
The water inlet hose has not
been correctly laid.
The siphon is blocked.
The water drain hose has not
been correctly laid.
The leak prevention system has
been triggered.
Remedy
Clean the tap
Turn the tap on.
Clean the filter in the threaded hose
fitting.
Cancel the dishwashing cycle (see
chapter: Starting a dishwashing
cycle), clean filters (see chapter:
Cleaning the filters), then start the
dishwashing cycle again.
Check hose installation.
Clean out siphon.
Check hose installation.
Turn off the tap and contact cus-
tomer service.