Table of Contents
Advertisement
colored stripe on the cable.
3.
Plug an IDE cable connector into the hard disk drive IDE connector (B). It
doesn't matter which connector on the cable you use.
4.
Plug a power cable from the case power supply into the power connector on
the hard disk drive (C).
When you first start up your system, the BIOS should automatically detect
your hard disk drive. If it doesn't, enter the Setup Utility and use the IDE Hard
Disk Auto Detect feature to configure the hard disk drive that you have in-
stalled.
Installing a CD-ROM/DVD Drive
1.
Install the CD-ROM/DVD drive into the drive cage in your system case.
2.
Plug the IDE cable into IDE1
(A). If you have already installed
an HDD, use the other connec-
tor on the IDE cable.
Note: Ribbon cable connectors are
usually keyed so that they can only
be installed correctly on the device
connector. If the connector is not
keyed, make sure that you match the
pin-1 side of the cable connector with
the pin-1 side of the device connec-
tor. Each connector has the pin-1
side clearly marked. The pin-1 side of
each ribbon cable is always marked
with a colored stripe on the cable.
3.
Plug an IDE cable connector into the CD-ROM/DVD drive IDE connector (B). It
doesn't matter which connector on the cable you use.
4.
Plug a power cable from the case power supply into the power connector on
the CD-ROM/DVD drive (C).
5.
Use the audio cable provided with the CD-ROM/DVD drive to connect to the
mainboard CD-in connector CD1 or CD2 (D).
When you first start up your system, the BIOS should automatically detect
your CD-ROM/DVD drive. If it doesn't, enter the Setup Utility and configure
the CD-ROM/DVD drive that you have installed.
CD1
Pin
Signal Name
1
CD IN L
2
GND
3
GND
4
CD IN R
Installing a Floppy Diskette Drive
CD2
Pin
Signal Name
1
GND
2
CD IN R
3
GND
4
CD IN L
17
Advertisement
Table of Contents
