Table of Contents
Advertisement
5.
Press the lever down.
6.
Apply thermal grease on top of the CPU.
7.
Put the CPU Fan down
on the retention module
and snap the four reten-
tion legs of the cooling
fan into place.
8.
Flip the levers over to lock the heat sink in place.
9.
Connect the CPU Cool-
ing Fan power cable to
the CPUFAN1 connec-
tor. This completes the
installation.
•
To achieve better airflow rates and heat dissipation, we suggest that
Notes:
you use a high quality fan with 4800 rpm at least.
•
CPU fan and heatsink installation procedures may vary with the type of
CPU fan/heatsink supplied. The form and size of fan/heatsink may also
vary.
Installing Memory Modules
This mainboard accommodates 168-pin 3.3V/184-pin 2.5V unbuffered
SDRAM memory modules. The memory chips must be standard or registered
SDRAM (Synchronous Dynamic Random Access Memory).
The CPU supports 100MHz system bus. The SDRAM DIMMs and DDRs can
synchronously work with 100 MHz or operates over a 133 MHz memory bus.
Note: Please set the correct jumper settings for JT1~JT11 first as described on
page 8 of this chapter.
14
Advertisement
Table of Contents
