Rear Panel; Remote Control Unit - Denon Professional DN-A200 Operating Instructions Manual

Getting Started
• When the VOLUME control knob is set just beyond
the "12 o'clock" position (over halfway), the
adjustments that can be made with the BASS and
TREBLE controls is decreased.
• When the VOLUME control knob is set to
maximum or turned fully clockwise, the base and
treble can no longer be adjusted.

Rear panel

!5
!6 !7 !8
!5
SIGNAL GND (ground) terminal
Connect the ground wire from your turntable
here.
NOTE:
• This terminal is not a safety ground.
!6
INPUTS terminals
Connect your source equipment here.
!7
Recording input/output terminals
(TAPE-1/CD-R and TAPE-2/MD)
Connect your recording equipment here.
!8
PRE OUT terminals
Use this to add such equipment as a power
amplifier or subwoofer.
!9
SPEAKER SYSTEMS terminals
Connect your speakers here.
@0
AC OUTLETS
Use these as the power outlets for other audio
devices. Check equipment power requirement
ratings before use (see the ratings as marked
on the rear panel). If in doubt consult with your
dealer or DENON PROFESSIONAL distributor.
NOTE:
r t y !2
• Functions , , and are only available
when the SOURCE DIRECT switch is set to
" £ OFF".
AC OUTLETS
AC 230V 50Hz
SWITCHED
TOTAL 100W (0.43A) MAX
!9 @0
• Short-circuiting plugs are inserted into the
PHONO input terminals. Remove these when
connecting a turntable. Be sure to keep it for
future use.
• The PRE OUT terminals are still active even when
using headphones. If you do not want any audio
signal to be output from the equipment
connected to the PRE OUTS turn off the
connected devices (power amplifier, etc.).
NOTE:
• NEVER insert the short-circuiting pin plug into
the recording output or PRE OUT terminals.
Doing so could result in damage.

Remote control unit

Amplifier operating
buttons
POWER button
This operates the main unit's
power.
Input source selector
buttons
These switch the input source.
MUTING button
Press this to mute the sound.
The power indicator on the main
unit blinks red.
Press again to produce sound.
Volume adjust buttons
These adjust the volume.
• The included remote control unit can be used to operate DENON PROFESSIONAL CD players, tape
decks and tuners.
• When using it, also refer to the operating instructions of the other devices.
• Some products may not be operable.
3
ENGLISH
Getting Started
DENON
PROFESSIONAL
product operating
POWER
buttons
CD
CD player block
1 2 3
0~9, +10 : Number buttons
4 5 6
REPEAT :
Repeat playback
RANDOM :
Random playback
7 8 9
, :
8 9 Search
1 :
Play
0 +10 REPEAT
:
3 Pause
:
2 Stop
RANDOM
CD player block
DISC SKIP
PHONO TAPE-1 / CD-R TAPE-2 / MD
This button selects the disc, when
using a DENON PROFESSIONAL
CD TUNER DVD / AUX
multi-disc CD player.
MUTING
TUNER block
TUNER DISC
TUNER PRESET •, ª
PRESET SKIP
These switch
channel.
Tape deck block
A / B REC
6 :
Rewind
:
7 Fast-forward
DECK
:
0 Reverse play
1 :
Forward play
A/B :
Switch between decks
A and B for double
decks
RC-1022
REC :
Record
:
3 Pause
:
2 Stop
ENGLISH
the preset