Sewing Embroideries; Instruction Book Rose - Husqvarna Viking Rose 605 User Manual

Sewing embroideries

1. Put on embroidery presser foot U,
see page 27.
2. Place the enclosed net over the
thread spool. Thread the machine
with embroidery thread as upper
thread. In this case you need not
place thread under the presser
foot. Use a fine thread as bobbin
thread.
3. Thread the bobbin thread
according to "Threading" on page
13 and check to be sure the
thread lies under the tension
springs. Cut the thread in the
thread cutter. Hint: Slide bobbin
cover on, then cut thread.
Always check there is enough
bobbin thread before starting a
new embroidery.
4. Insert the embroidery card. The
symbol flashing on the
display indicates if the
embroidery card is not inserted or
not inserted fully.
5. Select desired embroidery motif
from the Embroidery booklet.
Each embroidery has a number.
The buttons 1-35 are used to
select embroideries.
Select the number of the desired
embroidery on the stitch panel.
30
6. Start sewing by touching the
button or by pressing the foot
control. Hold the thread tails
when starting.
The machine always starts from
the center of the embroidery area,
sews a starting stitch up to the
beginning of the embroidery,
sews a few stitches more, gives a
"beep" and stops. A pair of
scissors flashing on the
display indicates that you can cut
the starting thread tail.
7. Touch the button
machine sews the rest of the
embroidery or up to next thread
color change.
Note: Be careful when working
within the needle and presser foot
area to avoid touching the start/stop
button or the foot control by
mistake.

Instruction book Rose

and the