Sewing Embroideries - Husqvarna Viking Scandinavia 400 User Manual

Embroidery

Sewing embroideries

1. Snap on embroidery presser foot
U, see page 27.
2. Place the enclosed net over the
thread spool. Thread the machine
with embroidery thread as upper
thread. In this case you need not
place thread under the presser foot.
Use a ne thread as bobbin thread.
3. Thread the bobbin thread
according to "Threading" on page
12 and check to be sure the thread
lies under the tension springs. Cut
the thread in the thread cutter.
Hint: Slide bobbin cover on, then
cut thread. Always check there
is enough bobbin thread before
starting a new embroidery.
4. Insert the embroidery card.
The symbol
the Infodisplay indicates if the
embroidery card is not inserted or
not inserted fully.
5. Select desired embroidery motif
from the Embroidery booklet.
Each embroidery has a number.
The buttons 1-35 are used to select
embroideries.
Select the number of the desired
embroidery on the stitch panel.
32
ashing on
6. Start sewing by touching the
button or by pressing the foot
control. Hold the thread tails when
starting.
The machine always starts from
the center of the embroidery area,
sews a starting stitch up to the
beginning of the embroidery, sews
a few stitches more, gives a "beep"
and stops. A pair of scissors
ashing on the display indicates
that you can cut the starting thread
tail.
7. Touch the button
machine sews the rest of the
embroidery or up to next thread
color change.
Note: Be careful when working within
the needle and presser foot area to
avoid touching the start/stop button
or the foot control by mistake.
and the