Changing The Needle, Lowering; Feed Teeth; Lowering The Feed Teeth - Husqvarna Viking Rose 605 User Manual

Changing the needle
!
Switch off the main switch.
1. Loosen the screw in the needle
clamp.
2. Remove the needle.
3. Push up the new needle with the
flat side away from you until it
will go no further.
4. Tighten the screw properly.
Always use needles of system
130/705H.

Lowering the feed teeth

The feed teeth are lowered when
you turn the dial to the left to
Turn the dial to the right to
you wish to raise the feed teeth. The
feed teeth will not come up until
you begin to sew.
The feed teeth are lowered when
sewing buttons and for free-hand
work.
By lowering the feed teeth it is
easier to get thick garments under
the presser foot. Do not forget to
raise the feed teeth before starting to
sew.
Note: The feed teeth are lowered
automatically when the embroidery
unit is put in place.
When removing the embroidery
unit, the feed teeth will raise as you
start to sew.
16
.
if
Instruction book Rose