Table of Contents
Advertisement
Physical Installation Requirement
This chapter illustrates basic installation of Wireless Analog Telephone Adapter ("WATA" in the
following term)
•
Network cables. Use standard 10/100BaseT network (UTP) cables with RJ-45 connectors.
•
TCP/IP protocol must be installed on all PCs.
For Internet Access, an Internet Access account with an ISP, and either of a DSL or Cable modem
Hardware Installation
Port Description
1
WAN
2
LAN
Phone
3
4
Line
5
Reset
External
6
Antenna Area.
7
12V DC
Preparations & Installation
Connect to the network with an Ethernet cable. This port allows
your WATA to be connected to an Internet Access device, e.g.
router, cable modem, ADSL modem, through a networking
cable with RJ-45 connectors used on 10BaseT and
100BaseTX networks.
Connect to PC with Ethernet cable. 1 port allows your PC or
Switch/Hub to be connected to the WATA through a
networking cable with RJ-45 connectors used on 10BaseT and
100BaseTX networks.
FXS port can be connected to analog telephone sets or Trunk
Line of PBX.
Line port can be connected to RJ11 PSTN line (VIP-161W
only)
Push this button until 3 seconds, and WATA will be set to
factory default configuration.
Used to Wirelessly Connect to 802.11b/g networks
802.11b: 11/5.5/2 Mbps
802.11g: 54/48/36/24/19/12/6Mbps
12V DC Power input outlet
2
Chapter 2
11
Advertisement
Table of Contents
