Table of Contents
Advertisement
Channel
WEP settings
WPA settings
Obtain IP address
automatically (DHCP)
IP address, Subnet
mask, and Gateway
NOTE
Note: To enable WLAN function, user must set these related parameters correctly at first.
Then power off the device and remove Ethernet cable from device. Power on the device
again and WLAN mode will be available accordingly.
nearest open network.
Chooses the wireless channel in use currently.
- Authentication:
Select Open or Shared Key System Authentication, depending on the
method used by your access point. Not all access points have this
option, in which case they probably use Open System, which is
sometimes known as SSID Authentication.
- WEP Mode:
The key types available depend on the access point being used. The
following options are available:
•ASCII - In this method the string must be exactly 5 characters for
64-bit WEP and 13 characters for 128-bit WEP.
•HEX - In this method the string must be exactly 10 hexadecimal (0-9,
A-F) characters for 64-bit WEP and 26 hexadecimal characters for
128-bit WEP.
- Web Key 1~4:
Key value of WEP.
- WPA Key:
Key value of WPA. The device uses a pre-shared key (PSK) for key
management. The pre-shared key can be entered either as Manual
hex, as 64 hexadecimal characters, or as a Passphrase, using 8 to 63
ASCII characters.
Enable this checked box when a DHCP server is installed on the
network to issue IP address assignment. With this setting, the IP
address is assigned automatically.
If you do not select Obtain an IP address automatically, then you need
to enter these network parameters manually.
When the configuration is finish, please click "OK" to save and enable
the setting.
34
Advertisement
Table of Contents
