To Install Bracket Mount; Connecting To Power - Lowrance Elite 5 Sonar/GPS Installation & Operation Manual

Installation

To install bracket mount:

1. Place the bracket on the desired mounting surface and mark the four mounting holes. If
you want to run the unit's cables up through the mounting surface, make a mark in the
center of the bracket mounting surface.
2. Drill pilot holes for the four mounting holes. If desired, use a 1-inch (25mm) bit to drill the
center cabling hole in the mounting surface.
3. If you are running the cables up through the mounting surface, push the cables through the
mounting surface and then pull them through the cabling hole in the center of the bracket.
4. Align the mounting bracket with the four mounting holes and use the supplied screws to
fasten it to the mounting surface.
5. Connect the display unit to the bracket mount.

Connecting to Power

1. Connect the black wire to a ground.
2. Attach a 3 Amp fuse to the end of the power wire and then connect the fuse to the positive
(+) terminal on the battery.
3. Connect the Power cable to the Power port on the back of the display unit.
NOTE: Use 18 gauge wire to extend the power or ground wires.
10