Installation
Elite Series Installation
This document covers the installation of the transducer and display unit installation,
which includes connecting the unit to power and installing the unit on the bracket
mount. Make sure you read all the installation instructions before drilling holes
in your vessel.
NOTE: This majority of this installation does not apply to the Elite 5m since it does not
have a transducer. Turn to pages 9-11 for information on mounting the display unit and
Transducer Installation
One piece bracket (Recommended Tools and Supplies — not included)
Drill
1" (25mm) or 5/8" (15mm) drill bit
#29 (0.136") (3mm) drill bit
Phillips (Slotted-head) screwdriver
connecting the unit to power.
Marine grade above-or-below waterline sealant
Marine grade epoxy (Shoot-thru-hull install only)
Zip ties (trolling motor mount)
TMB-S bracket kit (Skimmer trolling motor mount)
2