Installation; Assembly - Char-Griller AKORN Kamado Kooker 6719 Owner's Manual

Step 1
Place GRILL BODY upside down and install LEG BRACKETS with three (3) ½ inch hex bolts
each. Next install LEGS (3) with two (2) ½ inch hex bolts and two 1/4 inch lock washers
each into LEG BRACKETS, DO Not Tighten Bolts Until After Step #3. Screw CASTER onto
rear leg, lock CASTER before tightening. Make Sure the leg with the caster is in the back
and wheel support braces on the front legs are facing outward.
Step 2
Attach BOTTOM SHELF to LEGS with five 1/2 inch hex bolts and lock washers.
Step 3
Insert AXLE through front LEGS and BOTTOM SHELF. Tighten all bolts.
Step 4
Install one WASHER, COTTER PIN and HUB CAP onto the AXLE then slide the AXLE through
WHEELS and legs as shown. Finish by attaching 2nd WASHER, COTTER PIN and HUB CAP.
Wheel
Cotter Pin
Hub Cap
Washer
OM06719A.3
Axle
Leg Bracket
Grill Body
™ & © Char-Griller / A&J Mfg.
Bottom Shelf
Axle
Caster
8" Wheel
Leg Bracket
6