Safety instructions Your new freezer may have other functions compared to your previous one. Carefully read these instructions to learn how the appliance works and how to care for it. Keep the instruction booklet. It will come in handy if you later sell the cabinet or give it to somebody else.
Control Panel (ice dispenser) I. Yellow indicator lamp L. Photo-electric sensor. Lights up when the locking function Senses prevailing lighting conditions has been activated. (must not be covered). J. Button for locking function. M. Ice feeder Used for temporary disconnection of Activated when the pedal in the the locking function and alarm feeder is fully depressed.
Using the freezer To start the freezer and set the correct temperature Press the ON/OFF-button. The green indicator lamp lights. TURBO FROSTMATIC ALARM OFF ON/OFF The alarm sounds if the temperature inside the freezer reaches room temperature. Turn off the alarm by pressing the switch-off button.
DESIRED temperature means: The temperature that is required in the appliance, this can be adjusted to the temperatures shown in the display. The DESIRED temperature is indicated by flashing numbers. ACTUAL temperature means: The temperature display indicates the temperature that is currently present in the appliance.
Alarms and other features Function Errors If the appliance electronics detects a technical fault that needs to be rectified by customer service, the temperature display shows a square in the lower part of the temperature display or a letter. The red warning indicator flashes. The appliance will continue to operate in emergency mode.
Page 9
Temperature memory The temperature memory shows when an alarm has been triggered in the cabinet. The temperature memory operates as follows: When the temperature inside the freezer again falls below -11°C the audible alarm stops. The temperature display and the red warning lamp will flash to indicate than an alarm was triggered.
Page 10
To activate the locking function: Keep the buttons (J) and (K) pressed in at the same time for about three seconds. Activation is indicated by the yellow indicator lamp (I) lighting Lighting. The ice dispenser lighting (N) goes on automatically when ice is delivered.
Freezing Press the fast freeze button approx. 24 hours prior to placing the food in the freezer. You need not press the fast-freeze button when freezing smaller quantities of food during any 24-hour period. Fast freeze is automatically switched off apporox 50 hours after the button has been pressed.
Suitable storage periods Food purchased in frozen condition: Follow the advice on the maximum storage period indicated on the packaging. Fresh food frozen at home: Fatty and salty food should not be kept frozen for more than three months. Cooked food and low-fat food may be kept up to about six months. Lean food and berries can be kept for approximately one year.
Shelf for ice machine. Cannot be removed. Ice container. Can be removed. Lift the front edge and then pull out. When the ice container is pulled out, this stops all the functions of the ice machine. When re-fitting (if necessary), the ice container feed screw should be positioned against the rear flange.
Food Storage To obtain the best results from your appliance, neither hot foods nor · liquids which may evaporate, should be placed in the larder compartment. Avoid buying frozen food if you can not store it straight away. The use of ·...
Cleaning Clean the cabinet at regular intervals. Disconnect the appliance from electricity supply. Internal Cleaning Clean the inside and accessories with warm water and bicarbonate of soda (5ml to 0,5 litre water) Rinse and dry thoroughly. Regularly check the door seals and wipe clean to ensure they are clean and free from debris.
Servicing and cleaning the ice dispenser When necessary, clean the surfaces of the dispenser and the ice container that are accessible from the outside, using only a soft cloth and warm water. When necessary, the feeder and the ice container can be cleaned after removal of the surfaces accessible from the outside, using only a soft cloth and warm water.
Before contacting your local Service Force Centre check the following point: Problem Possible cause / Remedy " " is displayed in the Please contact your local Electrolux temperature display. Service Force Centre It is too warm inside the Set a lower temperature.
Page 18
No ice The ice machine is not switched on. Start the ice machine. See the section "Switching the ice machine on and off". No water supply. Carry out the necessary measures on the water supply. The ice dispenser lamp Leakage at the water connection. Remedy flashes the leakage and empty the box by pulling out the red plug.
Sound level in cabinet is The refrigerating system will always too high. produce some sounds. A pulsing sound is heard when coolant is pumped inside the cooling pipes. A ticking sound from the thermostat can be heard when the compressor switches on and off. The sound level varies depending on the operation of the cabinet.
Permissible water pressure (to ensure reliable function) The total flow in the system can vary, depending on local water conditions and/or water pressure. Lowest permissible water Consult your installer if water pressure. 1 bar (100kPa) pressure is less than 1 bar. Highest permissible water If water pressure exceeds 10 pressure.
Mounting the handles 1. Screw the top handle bracket to the handle rod. 2. Fit the bottom han dle bracket on the lower left-hand side of the door. 3. Fit the top handle bracket on the top left-hand side of the door and screw the handle rod to the bottom handle bracket.
Before the refrigerator is taken into use in its final location, ensure that the water connection has been correctly carried out, that there is no leakage at the connection to the refrigerator water valve or to the water tap, and that the four spacers are properly in position, see the illustration.
Installing the cabinet Make sure that the power plug is not squashed or damaged by back of the product. A damaged power plug may · overheat and cause a fire. Do not place heavy articles or the product itself on the power cord. there is a risk of a short circuit and 50mm ·...
Page 24
Cabinet is placed at a location whose ambient temperature corresponds to the climate classification*, for which the appliance is designed. * See on the rating plate on the inside of the appliance. The following table shows which ambient temperature is correct for each climate classification.