Putting In Extra Items Or Taking Items Out Before End Of Programme; Drying Cycle Complete / Removing Washing; Setup - AEG Electrolux LAVATHERM 58830 User Information

Putting in extra items or taking items out before
end of programme
1. Open door.
Warning! Laundry and drum can become hot. Risk of burns!
2. Load or remove laundry items.
3. Close door securely.
4. Press the

Drying cycle complete / removing washing

If the audible signal is set, at the end of the programme a 4x signal sounds and
the display alternates between the messages "ANTICREASE", "PLEASE EMPTY
THE TANK" and "PLEASE CLEAN THE FILTERS"
The drying cycle is automatically followed by a anti-crease phase
which lasts around 30 minutes. The drum rotates at intervals during
this phase. This keeps the laundry loose and free of creases. The laun-
dry can be removed at any time during the anti-crease phase. (The
laundry should be taken out towards the end of the anti-crease phase
at the latest to prevent creases from forming.)
1. Open door.
2. Before removing the laundry, remove fluff from the micro-fine
filter. It is best to use a damp hand for this purpose (see "Cleaning
and maintenance" section).
3. Remove laundry.
4. Turn the programme knob to O OFF.
Important! After each drying cycle
– clean the micro-fine filter and fine filter,
– drain the condensed water container
(see section "Cleaning and maintenance").
5. Close door.

Setup

The special functions that can be set under Setup remain permanently stored
independent of each drying cycle – even after the appliance has been switched
off or the mains plug has been removed from the socket.
START/PAUSE button to continue the drying cycle.
19