Changing Bulb For Inside Light - AEG Electrolux LAVATHERM 58830 User Information

Programme stops midway,
display shows:
THE TANK IS FULL,
PLEASE EMPTY.
Drying cycle ends
shortly after programme
starts. Display
shows: PLEASE CHECK
THE LOAD.
Washing is heavily
creased.

Changing bulb for inside light

Only use a special bulb which is designed specially for dryers. The special bulb
is available from the after-sales service, ET-Nr. 112 552 000-5.
Warning! Do not use standard bulbs! These develop too much heat and
may damage the machine!
Warning! Before replacing the bulb, disconnect the mains plug; with a
permanent connection: fully unscrew or deactivate the fuse.
1. Unscrew covering bonnet from above bulb (this can be found directly behind
the loading aperture, at the top; refer to "Description of machine" section.)
2. Replace defective bulb.
3. Screw covering bonnet back down.
Warning! For reasons associated with safety, the covering bonnet must
be screwed down tightly. If this is not done, the dryer must not be operated.
30
Problem
Condensate tank is full.
Not enough washing loaded
or washing loaded is too
dry for selected programme.
Possibly too much washing
was loaded.
Possible cause Remedy
Empty condensate tank,
then start programme with
the START/PAUSE but-
ton.
Select Timed Drying or hig-
her
degree of dryness (e.g.
INTENSIVE DRY
instead of
STORAGE DRY).
Observe recommended
loads.