Vehicles with serial number greater than 17063.
(See brass tag near top of left rear shock absor e
1. Put the vehicle in neutral.
2. Loosen the cable adjusters behind the dash board. (photo on left)
3. Make sure the selector lever on the dashboard is in neutral.
4. Make sure the transmission is in neutral. You can check by turning the key to Start. The
engine will only turn over if the transmission is in neutral.
5. Pull the slack out of both cables (but do not stretch the springs) and tighten the adjuster
nuts.
If you have tried all of this and it is still not operating correctly, you may need new cables. Please
call Brister's Customer Service at 1-866-646-5278. Have your serial number handy when you call.
b r)
25