Gear Spacing Adjustment - BRISTERS TRAIL WAGON Operator's Manual

(part #20843). Torque the oil drain plug to 9
ft*lbs.
4. Remove the oil fill plug using a 5/16" hex key
wrench.
5. Add 150 ml. (5 oz.) of Mobil fluid 424
Brister's part # 20848 (note: do not use any
other type of oil in this system or the 4WD
will not operate properly!)
6. Reasse mble the oil fill plug into the gearcase
and torque to 10 ft*lbs.

Gear Spacing adjustment

1. Locate set screw on front gear box.
2. Turn clockwise until you feel re
3. Turn back counter clockwise ¼ turn.
Rear Tr ansaxle Gear Box – It is recommended that
the oil b e changed once a year or after 600 hours. See
page 18 of owner's manual.
90˚ Transfer Gear Box – It is recommended that the
oil be ch anged once a year or after 600 hours.
sistance.
Gear
Spacing
Adjusting
Screw
1. Remove the oil drain plug located on the
bottom of the gearcase using a ¼" hex key
wre nch.
2. Let all the oil drain o
discard the oil properly.
3. Be sure to clean off any debris on the dr
plug and reinstall. Torque oil drain plug to 10
ft*lbs.
4. Remove the oil fill plug using a ¼" hex key
wrench.
5. Add 200 ml. (7 oz.) of 80W90 gear oil.
6. Reassemble the
and torque to 10
Strut ball joint lube – It is recommended that the
lower strut ball joint be lubricated every 3 months or
after driving in water, mud or dusty conditions. The
grease fitting is located on the back side of the stru
(see photo)
ut of the unit. Catch and
oil fill plug into the gearcase
ft*lbs.
Transfer
Gear Box
Oil fill
Grease
fitting
ain
t.
22