Electrical Connections - A.O. Smith Jaguar HSE-SCJ-015 User Manual

Water Filling
1. Open a hot water faucet nearby to permit the air to escape.
2. Open the cold water inlet valve fully, filling the heater and the piping.
3. Close the hot water faucet when water flows.
4. Check all the connections to see if there is any leakage. In case of a leakage, drain the
heater completely, repair the leaking joint and then refill the heater.
Fig. 5 Installation diagram
Red Cap
*Flexible Hose
Hot Water Tap
*Flexible Hoses to be procured by the customer, not part of standard product.

Electrical Connections

The power cord and plug are connected with this water heater. Find a separate socket for
power plug and make sure the socket is in firm contact with the plug. Ensure that reliable
earthing has been done.
Caution:
• Connect the water heater using independent sockets. Do not use adapters. Use
multimeter to check whether the live line and neutral line are not reverse, to ensure
complete safety.
• Before installing the water heater confirm that the power of water heater matches
electric meter capacity and supply wire.
• The water heater should be earthed reliably. It is prohibited to connect the earth wire
to neutral wire or tap water pipe.
Blue Cap
Safety Valve
Lever
Discharge Tube
*Flexible Hose
Cold Water Tap
To Drain
4