Wall mounting
To wall mount your Freestyle 120 Plus
Before you start ensure that the telephone is
in easy reach of the power supply and a
telephone socket. Ensure that the wall can
support the weight of the unit.
WALL PLUG
SCREW
WALL
Use the template on the following page to
•
mark the positions of the screws.
Drill two holes for the screws and insert the
•
wallplugs provided (if required).
Put the screws into the wall leaving about
•
5mm of screw exposed to mount the
stand/bracket.
Hook the stand/bracket over the screw heads
•
to check if it fits correctly, then remove again.
Attach the stand/bracket by hooking
it over the screws protruding from
the wall.
Spare parts for your Freestyle 120 Plus are
available from your BT shop or supplier, or you
can contact us on Lo-call 0345 697146 between
9.00am and 5.30pm Monday to Friday.
Ensure that the power supply and the
•
telephone lines are connected to the base
unit, then fit the lines into the channels on
the bottom of the base unit securing the
lines under the small tabs.
Any spare length of mains and telephone
•
lead can be stored in the hollow portion of
the wall bracket, but they should not be
wound around each other.
Fit the top end of the base unit over the lugs
•
at the top of the wall bracket.
Ensure that the lines are fitted into their slots
•
at the bottom of the wall bracket, clip the
base unit to the bottom of the wall bracket.
Place the wall bracket (the thin end of the
•
wedge at the top) over the screw heads and
pull down as far as possible to secure.
29