Advertisement
• Unit will not respond to any
button press.
• No display or display corrupted.
• Unit will not respond to remote
control commands.
Helpline
Lo
Microprocessor lock up.
You may be calling through a pulse
dialling exchange or the telephone you
are using may be set to pulse dialling.
You may be pressing the telephone
buttons too quickly.
You may be using an incorrect access
code.
Press reset and set up the answering machine
again. If this does not work, remove the back-up
batteries unplug from the power supply for 30
seconds then plug back in, refit back-up
batteries and set up the answering machine
again.
Check that the telephone you are using is set to
tone dialling. If it is connected to a pulse dialling
exchange, you will need to use a tone caller.
Press each key firmly and pause briefly before
pressing the next key.
Check your code when you return by pressing
the
button.
CODE
Advertisement
