Advertisement
• No dialling tone.
• Telephone will not dial out.
• Telephone cannot receive calls.
• Beeps six times and drops calls.
• You have dialling tone but the
telephone will not dial out.
• Handset does not ring.
• No lights on handset.
• Handset does not ring, but lights
show on the handset.
• Base unit does not ring but lights
show on base unit.
• The base-unit rings too loudly /
softly
Loss of security code.
Telephone not connected to telephone line.
Mains disconnected and back-up batteries
are not installed or are flat.
Power cut and back-up batteries are not
installed or are flat.
Handset battery pack is discharged.
You may be trying to use tone dialling on a
pulse dialling exchange.
You are connected to a PBX and are not
dialling the access code.
Handset discharged.
The handset may be set to ramped ringing.
It takes 4 to 6 rings to reach maximum
volume.
Telephone not connected to the telephone
line.
The base ringer switch is set to
Line fault or faulty socket
The ringer switch on the base unit is set to
/
HI
LO
Replace handset on base unit for 10 seconds
and try again. If this does not work, disconnect
the handset battery from the handset for 30
minutes. Also disconnect the mains power and
back-up batteries. Then reconnect the battery
and reconnect the base unit to the mains, then
replace the handset on the base unit for 10
seconds and try again.
Plug the telephone into the telephone line.
Reconnect and install or replace back-up
batteries.
Wait until the power is restored and install or
replace back-up batteries.
Place handset on base unit and recharge for 24
hours ensuring charge light in on.
Set mode switch to
Use the PBX access code.
Place handset on base unit and recharge for
24 hours.
This is not a fault. You may change ring mode to
constant.
Plug the telephone into the telephone socket.
.
Set the base ringer switch to
OFF
Try the telephone on another socket or another
line. If the telephone works contact BT or your
public switched telephone network operator for
repairs to the line or socket.
Set the ringer switch on the base unit
accordingly.
(pulse dialling).
P-E
or
HI
LO
Advertisement
