Wall-mounting
Your Freehand can be wall-mounted
using the bracket provided.
You can use the bracket as a
template to mark where the screws
should go into the wall.
Before you wall-mount your Freehand,
check that:
the wall can support the weight of the
•
phone;
the phone can reach the power socket
•
and the telephone line socket with the
cables provided;
the position you choose leaves
•
sufficient space so that the phone
(which is larger than the bracket) is
clear of any obstruction on the wall,
such as a shelf or cupboard.
Spare parts for your Freehand are
available from your BT shop or
supplier, or you can contact us on
Lo-call 0845 7697146 between 9.00am
and 5.30pm Monday to Friday.
16
Drill two holes for the screws and
•
insert the wallplugs provided (if
required).
Drive the screws into the wall,
•
leaving about 4mm free on which
to mount the bracket.
Hook the bracket over the screw
•
heads to check if it fits correctly,
then remove again.
Make sure that the power supply
•
and the telephone cables are
connected to your Freehand, then
fit the cables into the channels on
the bottom of the phone.
Clip the bracket onto the phone as
•
shown on the next page. Push the
four clips into their slots on the
back of the phone and slide the
bracket towards the top of the
phone.
Hook the bracket with the phone
•
attached over the screw heads.
Attach the bracket by
hooking it over the screws
protruding from the wall.