Headstock,Tailstock, And Tool Rest Assembly - RIDGID WL1200 Owner's Manual

Headstock,Tailstock, and Tool Rest Assem-
bly
1. Find the following:
1 Tube
1 Large Tool Rest
1 Tailstock
2 Lever Assembly
1 Socket Set Screw M10 x 1.5-12
1 Tool Rest Holder/Clamp Support Assembly
2 Brass Shoe Locks
1 5mm Hex "L" Wrench
2. Place the tube assembly on your workbench as shown.
Always keep the squared key section straight down.
3. Slide the tube into the headstock until it stops against
the squared key section. Insert locking setscrew and
tighten with 5mm hex "L" wrench.
4. Slide the tool rest holder/clamp support assembly onto
the middle of the tube. Assemble lock lever as shown.
5. Set large tool rest in tool rest holder and install locking
lever as shown.
Tube
Large Tool Rest
Tool Rest Holder/
Clamp Support Assembly
Spindle Pulley
Stock-Tube Locking
Screw in Rear of
Headstock
Clamp Support
Headstock
End
Brass Shoe
13
Lever Assembly
Brass Shoe Lock
Tailstock
Socket Set Screw
M10 x 1.5-12
5mm Hex "L" Wrench
Tube Assembly
Squared Key Section
Headstock Spindle
Tube
Squared Key
Section
Lock
Lever
Assembly
Tool Rest
Lever Assembly