Table of Contents
Advertisement
User Manual
Single or '1+N' UPS System
8 Chapter 8 - Operator Control and Display Panel
8.1
Introduction
On the front of the UPS there is a display and control panel, from which it is possible to easily verify the status of the
UPS including all the measured parameters and alarms of the UPS and battery discharge status. The operator control
panel is divided into three functional areas:
* - 'mimic LED display' and Inverter control switch
* - 'operator panel '&'LCD display'
* - 'bargraph section'
As can be seen the left section consists of LEDs, which indicate the operational and alarm status of the system by
turning ON or OFF or by flashing ON/OFF.
The middle section of the operator control and display panel consists of a LCD ( Liquid Crystal Display ) and its
associated switches.
The following functional area (right section) shows the various UPS load and battery charging conditions.
Liebert Hipulse E
Figure 8-1 UPS Operator control/display panel
(07/04)
Chapter 8 - Operating Instructions
Operator Control and Display Panel
Page 8-1
Advertisement
Table of Contents
