Yamaha XJ6S Owner's Manual page 86

PERIODIC MAINTENANCE AND ADJUSTMENT
7. Remove the wheel. NOTICE: Do
not apply the brake after the
wheel has been removed to-
gether with the brake disc, oth-
erwise the brake pads will be
forced shut.
[ECA11071]
To install the rear wheel
1. Install the wheel and the brake cal-
iper bracket by inserting the wheel
axle from the right-hand side.
TIP
G Make sure that the retainer on the
swingarm is inserted into the slot in
6
the brake caliper bracket.
G
Make sure that there is enough
space between the brake pads be-
fore installing the wheel.
1
EAU48650
1. Slot
2. Retainer
2. Install the drive chain onto the rear
sprocket.
3. Install the axle nut.
4. Take the motorcycle off the center-
stand so that the rear wheel is on
the ground, and then put the side-
stand down.
5. Adjust the drive chain slack. (See
page 6-26.)
6. Tighten the axle nut, and then
tighten the locknuts to the speci-
fied torques.
6-41
Tightening torques:
2
Axle nut:
90 Nm (9.0 m·kgf, 65 ft·lbf)
Locknut:
16 Nm (1.6 m·kgf, 11 ft·lbf)