Table of Contents
Advertisement
High safety levels
The individual zones will only get
hot when a pan with a magnetic base
is placed on them. It is impossible to
turn on an empty zone. When you
remove the pan from a lighted zone,
the zone will turn off even if you do
not switch it off. Remember that
there will still be residual heat in the
vitroceramic hob. The zone will
remember the last setting for about
20 seconds.
Overheating protection
When a pan is placed on a zone, the
pan will heat up. A sensor under
each zone measures the temperature
of the zone and the pan. If the tem-
perature gets too high, the zone will
automatically switch off.
Quick adjustment
When you turn on a zone, the pan
will become hot very quickly. When
you turn the heat down, the heat
quickly dissipates.
Easy cleaning
Any spills will not burn onto the vit-
roceramic hob as the area to the side
of the pan is not hot. Cleaning of
spills is therefore easy.
Power
The front zone has a facility for
switching in extra heat to give an
even quicker boiling time. When
using Power on the front zone the
rear zone cannot be set at the highest
setting. Information on how to use
Power is given in the Section "How
to use....Power".
Cooling fan
A fan protects the electronics from
overheating. When you have fin-
ished using the zones, the fan will
continue to run until the electronics
have cooled down.
Electronic control system
The hob has an electronic control
system to ensure precise heat control
of the zones. The electronics have
the following functions:
- Power, extra heat
- AUTOMAX, automatic boiling
- Safety shutdown
- Autostop. Automatic turning off of
zones
- Child safety
- Minute minder and timer
9
Advertisement
Table of Contents
