Starting A Cold Engine - Yamaha Fazer FZS1000 Owner's Manual

O PERATION AND IMPORTANT RIDING POINTS
5 -
WARNING
_
G
Become thoroughly
with all operating controls and
their functions before riding.
Consult a Yamaha dealer re-
garding any control or function
that you do not thoroughly
understand.
G
Never start the engine or oper-
ate it in a closed area for any
length of time. Exhaust fumes
5
are poisonous, and inhaling
them can cause loss of con-
sciousness and death within a
short time. Always make sure
that there is adequate ventila-
tion.
G
Before starting out, make sure
that the sidestand is up. If the
sidestand is not raised com-
pletely, it could contact the
ground and distract the opera-
tor, resulting in a possible loss
of control.
_
EAU00373

Starting a cold engine

In order for the ignition circuit cut-off
familiar
system to enable starting, one of the
following conditions must be met.
G
The transmission is in the neutral
position.
G
The transmission is in gear with
the clutch lever pulled and the
sidestand up.
WARNING
_
G
Before starting
check the function of the igni-
tion circuit cut-off system ac-
cording
described on page 3-20.
G
Never ride with the sidestand
down.
_
EAU04710
_
The oil level warning light, coolant
temperature warning light and fuel
level warning light should come on
for a few seconds, then go off. If a
warning light does not go off, have a
EW000054
Yamaha dealer check the electrical
circuit.
the engine,
_
to the procedure
NOTE:
_
When the transmission is in the neutral
position, the neutral indicator light
should be on, otherwise have a
Yamaha dealer check the electrical cir-
cuit.
_
5-1
1. Turn the key to "ON" and make
sure that the engine stop switch is
set to " ".
CAUTION:
2. Shift the transmission into the neu-
tral position.
3. Turn the starter (choke) on and
completely close the throttle. (See
page 3-11 for starter (choke) oper-
ation.)
EAU00372
ECA00108