Yamaha FJR1300A Owner's Manual page 24

INSTRUMENT AND CONTROL FUNCTIONS
The average fuel consumption display
can be set to either "AV _ _ km/L" or
"AV _ _ L/100 km".
When the average fuel consumption
mode is selected, the display flashes
for five seconds, and then, depending
on the unit set, "AV _ _ km/L" (average
distance that can be traveled using 1.0
3
L of fuel) or "AV _ _ L/100 km" (average
amount of fuel necessary to travel 100
km) is displayed.
To reset the average fuel consumption
display, push the "RESET" button to se-
lect the mode again, and then push the
"RESET" button for 1 second while the
display is flashing.
NOTE:
G To switch between the two aver-
age fuel consumption displays,
push the "RESET" button for 1
second when either display is
shown.
G After resetting an average fuel
consumption display, "_ _" will be
shown for that display until the ve-
hicle has traveled 1 km.
CAUTION:
If there is a malfunction, "- -" will be
displayed. Have a Yamaha dealer
check the vehicle.
Ambient temperature,
neous fuel consumption and aver-
age fuel consumption modes (for
the UK only)
1. Ambient temperature/instantaneous fuel
consumption/average fuel consumption
2. "SELECT" button
3. "RESET" button
Push the "RESET" button to switch the
display between the ambient tempera-
ture mode and the fuel consumption
modes in the following order:
3-10
Air (ambient temperature) → MPG (in-
ECA15470
stantaneous fuel consumption) → AV_
_ MPG (average fuel consumption) →
Air (ambient temperature)
Ambient temperature mode
instanta-
1. Ambient temperature
This display shows the ambient tem-
perature from –9 °C to 50 °C in 1 °C in-
crements. The temperature displayed
may vary from the ambient tempera-
ture.
NOTE:
G If the ambient temperature falls be-
low –9 °C, a lower temperature
than –9 °C will not be displayed.