Changing The Brake And Clutch Fluids; Checking And Lubricating The Cables - Yamaha FJR1300A Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
significantly lower the boiling point
of the fluid and may result in vapor
lock.
G Brake fluid may deteriorate paint-
ed surfaces or plastic parts. Al-
ways clean up
immediately.
G
As the brake pads wear, it is nor-
mal for the brake fluid level to grad-
ually go down. However, if the
brake fluid level goes down sud-
denly, have a Yamaha dealer
check the cause.
6
Changing the brake and
clutch fluids
Have a Yamaha dealer change the
brake and clutch fluids at the intervals
specified in the NOTE after the periodic
spilled fluid
maintenance and lubrication chart. In
addition, have the oil seals of the brake
and clutch master cylinders and cali-
pers as well as the brake and clutch
hoses replaced at the intervals listed
below or whenever they are damaged
or leaking.
G
Oil seals: Replace every two
years.
G
Brake and clutch hoses: Replace
every four years.
EAU22750
Checking and lubricating the
cables
The operation of all control cables and
the condition of the cables should be
checked before each ride, and the ca-
bles and cable ends should be lubricat-
ed if necessary. If a cable is damaged
or does not move smoothly, have a
Yamaha dealer check or replace it.
Damage to the outer sheath may in-
terfere with proper cable operation
and will cause the inner cable to
rust. Replace a damaged cable as
soon as possible to prevent unsafe
conditions.
6-23
Recommended lubricant:
Engine oil
WARNING
EAU23100
EWA10720