Table of Contents
Advertisement
44
Cleaning and Care
Inserting the oven carriage door panels
1. From above insert the door glass panels at an
angle into the door profile at the bottom edge
of the door and lower them one after the oth-
er.
Insert the smaller panel first, then the larger
panel.
2. Place the facing on the side door frame with
both ventilation slits pointing towards the
door handle. Press the facing down and slide
away from the door handle. The facing clicks
into place. Check its position on both side
again.
3. Take hold of the door trim (B) at each side, po-
sition it on the inside edge of the door and
push the door trim (B) onto the upper edge of
the door.
On the open side of the door trim (B) there is a
guide bar (C). This must be pushed between
the outer door panel and the guide corner (D).
The clip seal (E) must be snapped in.
4. Replace the oven carriage door panels.
Advertisement
Table of Contents
