Installation Instructions
15
Installation Instructions
Safety instructions
Warning! This must be read!
Safety instructions when building in
The laws, ordinances, directives and standards in force in the country of use are
to be followed (safety regulations, proper recycling in accordance with the regu-
lations, etc.)
Installation may only be carried out by a qualified electrician.
The minimum distances to other appliances and units are to be observed.
Anti-shock protection must be provided by the installation, for example drawers
may only be installed with a protective floor directly underneath the appliance.
The cut surfaces of the worktop are to be protected against moisture using a
suitable sealant.
The sealant seals the appliance to the work top with no gap.
Ensure anti-shock protection through correct installation by a qualified installer.
Safety instructions when connecting to the electricity supply
If this appliance's mains cable is damaged, it must be replaced by a special cable
(type H05BB-F Tmax 90°C; or higher). The latter is available from the Customer
Care Department.
Observe electrical safety rules.
A device must be provided in the electrical installation which allows the appli-
ance to be disconnected from the mains at all poles with a contact opening
width of at least 3 mm.
Suitable isolation devices include line protecting cut-outs, fuses (screw type fus-
es are to be removed from the holder), earth leakage trips and contactors.