Table of Contents
Advertisement
Installation Instructions
Safety instructions
Warning! This must be read!
The laws, ordinances, directives and
standards in force in the country of use
are to be followed (safety regulations,
proper recycling in accordance with the
regulations, etc.)
Installation may only be carried out by a
qualified electrician.
The minimum distances to other appli-
ances and units are to be observed.
Anti-shock protection must be provided
by the installation, for example drawers
may only be installed with a protective
floor directly underneath the appliance.
The cut surfaces of the worktop are to
be protected against moisture using a
suitable sealant.
The sealant seals the appliance to the
work top with no gap.
Avoid installing the appliance next to
doors and under windows. Otherwise
hot cookware may be knocked off the
rings when doors and windows are
opened.
Risk of injury from electrical
current.
• The appliance must be free of volt-
age when installing and uninstalling.
• Observe connection schematic.
• Observe electrical safety rules.
• Ensure anti-shock protection
through correct installation by a
qualified installer.
• The appliance must be connected to
the electrical supply by a qualified
electrician.
installation instructions electrolux 23
Risk of injury from electrical
current.
Loose and inappropriate plug and sock-
et connections can make the terminal
overheat.
• Have the clamping connections cor-
rectedly installed by a qualified elec-
trician.
• Use strain relief clamp on cable.
• This appliance's mains cable is fixed
directly to the board. If the mains ca-
ble is damaged, it must only be re-
placed by a qualified ecletrician or
our Customer Care Department.
• This appliance's mains cable must
be a special cable (type H05BB-F
Tmax 90°; or higher). The latter is
available from the Customer Care
Department.
A device must be provided in the electri-
cal installation which allows the appli-
ance to be disconnected from the mains
at all poles with a contact opening width
of at least 3 mm.
Suitable isolation devices include line
protecting cut-outs, fuses (screw type
fuses are to be removed from the hold-
er), earth leakage trips and contactors.
Advertisement
Table of Contents
