Prior To Using For The First Time; Setting/Changing The Time - AEG COMPETENCE B 8100 User Instructions

Prior to Using for the First Time

Setting/Changing the Time

Following the connection of mains power, the TIME function indicator
and the temperature/time display flash.
You must then first set the time. The time can set with the appliance
either switched on or off.
If the time has not been set, the oven cannot be switched on.
3
Setting the Time
1. Press the + or - button and set the required time.
0
Each time the + button is pressed the time advances one minute, and
each time the - button is pressed, the time is set back by one minute.
2. Press the clock W button or wait for approx. 5 seconds.
The time in the temperature/time display changes from flashing to con-
tinuous display. The time is thus set.
If the + or - button is held pressed for more than 2 seconds, the min-
3
utes start to run forwards or backwards until the button is released. In
this way you can reach the required value more rapidly.
If the appliance has been isolated from the mains, e.g. due to a fuse
3
being switched off, the temperature/time display starts flashing again.
In this case, set the time again as described.
Operating Instructions
15