Before & After Competition Maintenance; Between Motos & Practice Maintenance; After Competition Maintenance - Honda CRF250R 2005 Owner's Manual

Before & After Competition Maintenance
Between Motos & Practice Maintenance
After practice or between motos you have a
chance to make additional checks and
adjustments.
• Clean accumulated dirt from under the
fenders and off the wheels, suspension
components, hand grips, controls, and
footpegs. A stiff, nylon parts cleaning brush
works well.
• Check tire air pressure.
• Check spoke tension and rim lock nut security.
• Check sprocket bolt and nut security.
• Clean the sides of the drive chain with a stiff,
nylon parts-cleaning brush. Lubricate and
adjust the chain as necessary.
Do not perform maintenance while engine is
running.
Injury to your fingers or hands may result.
• After adjustment, check that the chain adjuster
index marks (1) are in the same position on
each side. This will ensure that the rear wheel
is in proper alignment and allow
maximum performance from the rear disc
brake. Maintaining proper wheel alignment
will also extend brake pad wear.
26
Servicing Your Honda
(1) chain adjuster index marks
• Suspend the front wheel above te ground and
use the pressure release screws (1) to release
the built-up pressure (in excess of normal
atmospheric pressure: 0 psi) in the fork tubes.
This pressure is caused by normal fork action
while riding. (If you are riding at altitude,
remember that fork pressure of 0 at sea level
will increase as elevation increases.)
(1)
(1) pressure release screws

After Competition Maintenance

It is important to the long term performance of
your CRF to practice a consistent maintenance
(1)
program. Right after the event is a good time to
begin your next maintenance cycle.
After Race Lubrication
Apply a light coating of rust-inhibiting oil to the
drive sprocket and any steel portions of the
chassis or engine where the paint has worn away.
This will prevent rusting of the exposed metal.
Apply rust-inhibiting oil more heavily if the
event was particularly wet or muddy. Take care
to avoid spraying any oil near the disc brakes or
the disc rotors.
Remove the drive chain, clean it, and lubricate
the chain and sprockets. Be sure the chain is
wiped clean and is dry before applying the chain
lube.
Take care to prevent catching your fingers
between the chain and sprocket.