Honda CRF250R 2005 Owner's Manual page 109

19.Clean the threads of the fork protector (15)
bolts and axle holder thoroughly.
Apply locking agent to the bolt threads.
Install the fork protector and tighten the bolts
to the specified torque:
5.1 Ibf·ft (7 N·m, 0.7 kgf·m)
(15)
(15) fork protector
20.Clean the surfaces where the axle and axle
clamps contact each other.
Install the left and right side collars into the
wheel hub. Insert the front axle shaft through
the wheel hub from the right side. Make sure
the front axle shaft is seated firmly onto the
left fork leg clamp inner surface. Tighten the
axle nut (16) to the specified torque:
65 Ibf·ft (88 N·m, 9.0 kgf·m)
(16)
(16) axle nut
Front Suspension Adjustments
21.Align the brake caliper (17) and hose with the
left fork leg, making sure that the brake hose
is not twisted.
22.Clean the threads of the caliper mounting
bolts (18) and brake caliper thoroughly.
Apply locking agent to the bolt threads.
Install the brake caliper on the slider and
tighten the caliper mounting bolts to the
specified torque:
22 Ibf·ft (30 N·m, 3.1 kgf·m)
WARNING
An improperly routed brake hose may
rupture and cause a loss of braking
efficiency. Route the hose carefully
NOTICE
Fit the brake caliper over the disc, taking care
not to damage the brake pads.
(18)
(17) caliper
(18) caliper mounting bolts
Adjustments for Competition
(17)
(cont'd)
105