Battery Installation & Charging - AT&T E5901 User Manual

Getting started
Battery installation & charging
After installing the battery, it may have enough charge to allow some calls. For
best performance, place each handset in the telephone base or a charger and
allow to charge for 16 hours before use. You can keep the batteries charged by
returning the handsets to the telephone base or chargers after each use. When
the battery is fully depleted, a recharge takes about 12 hours. The average talk
time on a fully charged battery is about eight hours depending on environmental
conditions, and the standby time is approximately five days. and the standby time is approximately five days.
1. Plug the small
end of the smaller
power adapter into
the jack on the
underside of the
charger, then route
the cord through
the slots as shown.
2. Plug the large end
of the smaller power
adapter into an electrical
outlet not controlled by
a wall switch.
6. The battery may have
enough charge to allow
for some calls. For best
performance, place
handset in telephone
base or charger to
charge for at least 16
hours before first use.
Caution: Use only the supplied rechargeable battery or replacement battery (model
27910, part number 89-0099-00-00). To order a replacement battery, visit our website at
www.telephones.att.com or call 1 (800) 222-3111. In Canada dial 1 (866) 288-4268.
time is approximately five days.
3. Plug the battery Plug the battery
securely into the plug
inside the handset bat-
t e r y c o m p a r t m e n t ,
matching the color-
coded label.
LOW BATTERY
Low battery indicator
Return handset to telephone
base or charger to recharge
when this symbol flashes, the
handset screen is dim or com-
pletely clear. (Handset will
beep when battery is low.)
4. Place the battery Place the battery
and wires neatly
inside the compart-
ment.
7
5. Slide battery
compartment cover
towards the center
until it clicks into
place.
To replace the battery,
press in and push
outward on the tab
to open the battery
compartment cover.
Lift out the old battery
and disconnect it from
the compartment.
Follow the instruc-
tions on this page to
install and charge the
new battery.