Telephone Line Cord - AT&T E5901 User Manual

Getting started
Telephone base installation
1.
Plug one end of the

telephone line cord

into the telephone jack
at the bottom of the
telephone base.
5.
Plug the other end
of the telephone line
cord into a telephone
jack.
DSL filter
(Optional for DSL users,
see number four in the
NOTES section, below.)
NOTES:
1. Use only the power cord supplied with this product, if you need a replacement, visit our web-
site at www.telephones.att.com or call 1 (800) 222-3111. In Canada dial 1 (866) 288-4268.
2. Be sure to use an electrical outlet not controlled by a wall switch.
3. This power adapter is intended to be plugged into a vertical wall outlet or a floor outlet. The
prongs are not designed to hold the plug in place if it is plugged into a ceiling, under-the-table or
cabinet outlet.
4. If you receive high speed internet through your telephone line (commonly referred to as DSL), and
you are experiencing interference during telephone conversations and/or your caller ID features
are not functioning properly, install a DSL filter to the telephone line between the telephone base
and the telephone wall jack. Contact your DSL service provider for a DSL filter.
2.
Plug the small end of the
larger power adapter into the
power jack at the bottom of
the telephone base.
Telephone line cord
6
3.
Route cords
through slots.
4.
Plug the large
end of the larger
power adapter into
an electrical outlet
not controlled by a
wall switch.