Integrated Peripherals - Gigabyte GA-8I865PEM-775 User Manual

2-3

Integrated Peripherals

On-Chip Primary PCI IDE
On-Chip Secondary PCI IDE
On-Chip SATA
x SATA Port0 configure as
SATA Port1 configure as
USB Controller
USB 2.0 Controller
USB Keyboard Support
USB Mouse Support
AC97 Audio
Onboard H/W LAN
Onboard LAN Boot ROM
Onboard Serial Port 1
Onboard Serial Port 2
UART Mode Select
x UR2 Duplex Mode
Onboard Parallel Port
Parallel Port Mode
x ECP Mode Use DMA
: Move Enter: Select
F5: Previous Values
On-Chip Primary PCI IDE
Enabled
Disabled
On-Chip Secondary PCI IDE
Enabled
Disabled
On-Chip SATA
Disabled
Auto
Manual
SATA Port0 configure as
IDE Pri. Master
IDE Pri. Slave
IDE Sec. Master
IDE Sec. Slave
SATA Port0
SATA Port1
SATA Port1 configure as
The setting depends on "SATA Port0 configure as" item setting. (Default: SATA Port1)
GA-8I865PEM-775 Motherboard
CMOS Setup Utility-Copyright (C) 1984-2004 Award Software
Integrated Peripherals
[Enabled]
[Enabled]
[Auto]
SATA Port0
SATA Port1
[Enabled]
[Enabled]
[Disabled]
[Disabled]
[Auto]
[Enabled]
[Disabled]
[3F8/IRQ4]
[2F8/IRQ3]
[Normal]
Half
[378/IRQ7]
[PRINTER]
3
+/-/PU/PD: Value
F6: Fail-Safe Defaults
Enable onboard 1st channel IDE port. (Default value)
Disable onboard 1st channel IDE port.
Enable onboard 2nd channel IDE port. (Default value)
Disable onboard 2nd channel IDE port.
Disable onboard Seria ATA function.
When there is no device to be plugged in IDE1 or IDE2, SATA controller will
remap to IDE controller. (Default value)
Set SATA mode manually from "SATA Port0 configure as" item.
Set SATA controller to compatible mode. This mode will remap SATA Port 0 to
IDE Primary Master.
Set SATA controller to compatible mode. This mode will remap SATA Port 0 to
IDE Primary Slave.
Set SATA controller to compatible mode. This mode will remap SATA Port 0 to
IDE Secondary Master.
Set SATA controller to compatible mode. This mode will remap SATA Port 0 to
IDE Secondary Slave.
Set SATA controller to native mode(Serial ATA mode - SATA Port 0). This mode
is only supported by Windows XP or later. (Default value)
Set SATA controller to native mode(Serial ATA mode - SATA Port 1). This mode
is only supported by Windows XP or later.
- 34 -
Item Help
Menu Level
F10: Save ESC: Exit
F7: Optimized Defaults
F1: General Help